A mini of R2-D2. I really shot myself in the foot with the scaling ( I wanted it to be as close as possible to my other minis), but after a lot of prototyping, it's finally done. Still a bit too big, but hey… I wanted it that way.
 

 The head, legs and feet can be moved and posed. You will need 6x2 magnets, and quite a lot of them. 14 in total, if you dont have any there are pins, but magnets are the way to go…

Assembly

You need a very clean plate, I used a mix of the Super tack plate and textured. The profile is optimized for a textured plate. 

Some post processing is needed. Cut away the brim and smooth with a VERY quick pass with a lighter. 

I needed to sand a little, however i adjusted the fit and it should fit without issues.

Each piece fits one way, so just check around until you got it, a very small touch of glue on the body (white part) and insert the piece

The top part of the leg takes 2 magnets, while the bottom only one magnet. Very important, otherwise it will not fit in the foot.

Add the rest of the pieces and thats it. I used SunLu PLA Blue which lacks pigment and is a little transparent. You should get better results with a more pigmented filament. I also added some filament changes to the dome so you get a better result (not shown in pictures)

Any issues, let me know :)

Boba Fett

Darth Vader

Obi-Wan

Stormtrooper

CHEWIE

C-3PO

B1