This rack is a 2 piece rack mount that supports your precious Lenovo Tiny from both sides and can be secured using the VESA bracket screw holes on the back (M3 Screws, 6mm works fine). The print takes around 2 Hours on an A1 and uses ~90g of filament!

This was designed around an M93P, but should fit other Lenovo Tiny machines and possibly other 1L tiny PCs.

NOTE: Due to the length of the M93P compared to the rack, The rear panel needs to sit inside the rails to support the rear without too much overhang, this may not fit in all racks! (See Photos)

Printed on an A1 at 30% infill with 0.2mm Layer height using eSun PLA+ (PETG is recommended for better thermal resistance, PLA Might sag over time!)