This M&M dispenser works for both mini and normal M&Ms, but it does not work for peanut or any other flavors. You need a little glue to assemble this frog. I used hot glue. the axles are made of filament allowing the device to rotate extruding the tongue. I printed this model in three different colors on three separate plates, but you can print it on one plate if desired.

Assembly Guide

Take a 3.75in (9.5cm) length of filament and thread the small arm pieces onto it then take a 1.5in (3cm) length and feed it through the tongue piece and both arm pieces, like is shown above. Hold onto this we will need it later.

Use a little glue and insert the eyes into their respective sockets in the top jaw.

Next add the bottom jaw and back throat pieces.

Insert the rails into their slots in the bottom jaw. If they don't seem to fit snuggly add a little glue.

Insert the tongue assembly from earlier and bend the filament into the holes in the side of both jaws, and glue them to the outsides of the top jaw.

Insert the two side throat pieces.

Glue the candy reservoir on top of the 2 side throat pieces. Make sure it sits flush.

Now enjoy your Frog M&M dispenser.