Pushstick V2.0 has arrived - it has been slightly redesigned:

• Safety - 15mm base (less wiggling from side to side on the board while cutting)
• Safety - the handle at 90 degrees angle moving the hand away from the blade
• Robustness - increased height of the shoe for extra durability under pressure while pushing
• Safety - still two notches - front and rear - either push with the front further away with your hand from the blade, or with the rear while pressing down the board but still higher from the blade
• Ergonomics - thicker handle so it's more convenient to keep in one's hand

Due to the size of the plate and the new angle of the handle now it's a one plate two part print which requires supports. I have customized where the supports go and where they shouldn't so please do not change the settings. The parts could be glue together or left as they are to allow disassembling for storage during long winter days.

I printed in PETG-HF but PLA should be relatively strong since no flexing is expected while in use. Still recommend printing in PETG(-HF).