A case for a Raspberry Pi 4 + SSD drive inspired by the classic Amiga 4000 look.

To get the led and the switch working in Raspbian, you need to change /boot/config.txt adding the following lines:

# HD led
dtoverlay=gpio-led,gpio=8,label=hdled,trigger=mmc1
# power indicator
gpio=4=op,dh
# start a system shutdown when the button is pressed
dtoverlay=gpio-shutdown

Connect the LEDs and the switch to the above mentioned GPIO pins.

BoM:

• 5 M3 screws (4 for the SSD, one to block the top part of the case)
• 4 M2.5 screws for the Pi (unless you prefer to use my “pi blocker”)
• 4 6x3 magnets for the front plate
• 1 green 5mm LED
• 1 yellow 5mm LED
• 2 330Ω resistors
• 1 6x6mm tactile switch
• some wires