This is a small LED-light which can be plugged into every USB-A port. Use it for camping, traveling, as a gift or just for fun. 

The small size makes it easy to carry without taking to much space. I designed it as a keychain, what makes it even more useful.

The brightnes is also adjustable.

It uses translucent PETG-Filament and works beautiful.

This kind of LED-USB-sticks is needed: [https://www.amazon.de/dp/B071FJP3QH?ref=ppx_yo2ov_dt_b_fed_asin_title](https://www.amazon.de/dp/B071FJP3QH?ref=ppx_yo2ov_dt_b_fed_asin_title) 

you can get them cheaper at Aliexpress!

Attention: 

The LED are getting warm when using it at maximum brightnes. So make sure to use it not longer than 10-15mins on maximum brightnes. Lower brightnes can be used a longer time without interruption. If you feel it getting hot just turn it off for a minute and it will be ready to use again.

Check out my profile for a much smaller version!

Printinstructions: 

• Use my 3mf file and translucent PETG for easy printing and follow the exakt instruction and pictures underneeth.

• Start printing and have an LED stick ready.

• If you use my 3mf file here is a pause at the right layerhight just to lay the USB-LED into your print:

• make sure it lays just as perfekt, as in the Picture: 

• Than resume the printing on your Display or App/Slicer:

• By tapping the black surface on the backside once, you will turn on the light. To turn it off just tap it again. 
• To adjust the brightnes, you must tap and hold as long as it reaches your prefered brightnes. First adjustment gos lower and adjusting it again it will go brighter.