This model has 3 plates containing 6 different circular bubble levels. All levels use the same unmounted circular level that can be found here: [https://www.amazon.com/dp/B07RKK22BF](https://www.amazon.com/dp/B07RKK22BF) (or 32x7 mm equivalent).

The levels are:

• Basic Level – for general leveling: consists of a printable base and screw on top. Also has an interior pocket for an optional 20x3mm magnet. The magnet I used was [https://www.amazon.com/dp/B09Y2VBF11](https://www.amazon.com/dp/B09Y2VBF11) but a Bambu Lab CA012 should also fit.
• Keychain Level – for general leveling. Consists of a printable base and screw on top. It also has a side loop for hanging your car and house keys from. 
• Tripod Level – Can slid under your tripod mounted camera so you can adjust the tripod level: consists of a printable base and screw on top.
• Hot Shoe Level – Attaches to your cameras hot shoe so you can adjust the cameras level. Consists of a printable base and screw on top.
• Screw Down Level – For use when a fixed level is needed. Consists of a printable base. I used three #4x3/8 inch screw (an M3 equivalent should work also).
• 4-Legged Level – For use when you want to check the level of a larger area. Consists of a printable base and screw on top.

Notes:

• The Hot shoe level uses supports and they a quite dense. I find that if I clip them, with side cutters, in various places they are much easier to remove.

If you’re looking for the more traditional rectangular level, these can be found at: [https://makerworld.com/en/models/1495871-level-assortment#profileId-1564210](https://makerworld.com/en/models/1495871-level-assortment#profileId-1564210)