Flipper zero case

as this is NOT behind a paywall, your support would be appreciated!

*********************************************************

MASSIVE SHOUTOUT TO TALKING SASQUACH FOR THE REVIEW/ HOW TO GUIDE!

*********************************************************

***UPDATED 18/09/2023***

Optimised case set for PCBWAY this is front v3 and rear v1 in one file ready to be uploaded and ordered, scailing pre done so you don't need to.

*********************************************************

***UPDATED 13/09/2023***

Opened up GPIO holes to 1.4x1.4mm as a revision to allow for resin prints with clear coat applied on top

*********************************************************

***UPDATED 27/08/2023***

*********************************************************

Replacement case for flipper zero.

Confirmed good fitment on my own personal flipper, and various others in the community.

To allow for manufacturing tolerances of the flipper, bump the scale to 100.29% respectively

beware of your iButton pins, i take no responsibility for you breaking them, it fits mine so it SHOULD fit yours.

seams are a little tight but it fits well.

Screen window sits in place (you can glue if you want)

IR Filter will fit in place also.

i spent a long long time making this happen, and i didn't want to butcher things like everyone else who “made one”

your window and IR filter will fit, without cutting them or shaving them down.

printed on a X1C @ 0.08 layer height

as this is NOT behind a paywall, your support would be appreciated!