Miniature tree house

Miniature tree house

I´m modelling a lot of planters and enjoyed the architecture contest. Therefore i worked on a decoration tree house to brighten up the growing offspring of my plants. Although i needed several attempts to make these little things printable it worked out!

I printed some parts for themselves cause i wanted for example the roof in a different color. In the print profile all parts are on the same plate. I highly recommend to use the preset brims for the roof and the bottom part. Because of the small surface the parts can easily snap off and ruin the print. Better to peel of 1 line of filament then the whole model. There might be stringing depending on the filament used. You can adjust the temperature or the speed. Otherwise just carefully (!!!) melt them with a heater.

I modeled a version where connections are possible, but the print is way too small for that. Therefore its necessary to use a small drop of glue for every part so it sticks together.

Have fun printing!

Descrição