Josh Presents:

“Water Spreader”

The Water Spreader easily slides onto the standard Quick Connect system, its designed to evenly spread the water in your garden,

or spray your freinds in a simple yet elegant way. After many of failed prints and some fine tuning in the bambu studio 

it now prints like a dream.

Use:

You may be asking yourself: Why do I need this? Although we try to, its very hard to evenly water your garden with a standard hose but with the Water Spreader you can ensure that every plant gets its fair share of water, it's basically a watering can on steroids.(You may also spray your friends)

Assembly:

After taking the Water Spreader of the print bed all you have to do is first take of the small supports, i recommend a pliers then slide a 10mm (inner diameter) and 2.5mm (cross sectional diameter) O ring onto the first divet, as shown below.

Design:

The design may seem simple but it may shock you that this took 10 attempts due to some strange fluid mechanics going on inside the chamber that caused what to only exit out of half the holes.After some redesigning and talking to my physics professor I managed to fix the problem, here below you can see the chamber, try guess what was wrong with it before!

Have fun!