Makerworld limited the file size, to get those rock textured exteriors you can check my printables post.

MOTH - Transformable ITX PC Case by Fanasia Lab | Download free STL model | Printables.com

Specs

About the design

The MOTH is a compact computer case featuring a linear rods folding frame and a quick-release exterior mechanism, enabling high maintainability and ease of installation. Its folding structure, inspired by the wing motion of moths or butterflies, allows the case to be either vertically folded to save desk space or laid flat to maximize heat dissipation. Users can easily access back area of motherboard to install m2 devices or cooler's screws. The case supports an ITX motherboard, SFX/SFX-L power supply, 280mm liquid cooling radiator, 315mm 3slots graphic card, and two 2.5-inch SATA hard drives. The large radiator permits the use of high-end CPU models on the motherboard. The exterior is equipped with quick-release clips at the bottom.

The design is optimised for consumer-grade 3D printers. Despite the complexity of the structure, the material waste rate is only about 4 per cent; all parts do not exceed a print area of 245x245x225mm, making online distribution possible. Users can also customise the materials or the model to create their own variations. I made a rock like exterior as an example, feel free to make your own variant.

The name MOTH is derived from Dive into the Flame, a track from the Armored Core 20th Anniversary Special Disk.

BOM List

2 x Φ4x300mm linear rods for front panel

16 x Φ5x300mm linear rods for frame and exterior

1 x 25cm dual reverse pcie riser cable

1 x 30cm C13 to C14 right-angle or up-angle power cord

(Ensure the C13 part outside the PSU when plugged in is below 16mm, here's an example)

Computer Case Extension Cord Power 90 Degree Angle Extension Cord 40cm - MODDIY

1 x ADT T8T-F6A 30cm extension wire cable

1 x ADT S5Tx2-F1B 40cm or 45cm extension wire cable 

(45cm is easier to install but slightly more expensive)

1 x 20cm led strip

(if your board got a RGB connector such as 5v3pin)

1 x 12mm led button switch thin variation likes the one below

DMWD 2pcs 12mm Super Mini Metal Waterproof Anti-Vandal Momentary Push Button Switch Silver Shell 1/2" Mounting Hole, 12V-24V ON Off 4Pins 1NO Plug in Halo Ring Green LED: Amazon.com: Industrial & Scientific

Numerous Φ6x2mm magnets

Numerous m3 screws and m3 hot pressing-in nuts, interior Φ4.4mm holes are for m3 hot pressing-in nuts

 (I didn't remember the accurate numbers but you can find it yourself by checking the model)

im currently busy with graduation stuffs so complete list and installation guide might be delayed a little bit but they're surely incoming.