Created this case because my JBL Wave Buds came without a cover or ear tips—super annoying. So I designed a clean, support-free print that’s easy to make and works great. Here's what you get:

✅ Features:

• Perfect fit – snug and secure for JBL Wave Buds
• No screws – held together with just 4 magnets (ø3x2mm)
• Durable hinge – uses a piece of filament instead of snap joints
• No rattle – lid stays closed tight with proper magnet alignment
• Easy charging – port hole fits all standard USB cables
• Express your self – fully supports coloring in Bambu Studio with AMS
• Support-free – no hassle with pesky supports

🛠️ Assembly Tips:

1. Insert the Lid: Align the hinge holes and push in a ~6 cm piece of 1.75 mm filament. Use pliers if it’s tight. If needed, pull both ends to slightly compress the filament and make it easier to slide in.
2. Install Case Magnets: Press 2 magnets (3x2 mm) into the holes on the case body using pliers—watch out, they’re small and slippery.
3. Align Magnet Polarity: Snap the other 2 magnets onto the installed ones to match polarity. Carefully close the lid so the loose magnets seat into the lid holes, then press them in.
4. Optional Glue: Add a small drop of super glue to each magnet hole for extra hold, but it's usually secure without it.