My take on a camera mount for my Ender 3v2. Bolts in place of the stock motor mount and adds both cable management options and the camera mounting point.

Highly recommend printing it in a material that's durable, heat and creep resistant. I doubt PLA will last long term, especially if the stepper is pushed hard and hot, plus eventually it will cold creep under the screw load which means your X stepper is no longer securely attached.

I'd suggest PETG as a bare minimum, mine is printed in ASA-CF for strength, creep and heat resistance. Plus it's very light and extremely rigid.

Recommend Bambu ABS-GF if you like colours.

My design reuses the stock mounting screws as well as the stock end-stop switch and it's screws.