This model allows you to attach 25mm o.c. multiboard small thread accessories to a Honeycomb Storage Wall (HSW) system.

Note that the parts are directional (there is a left, center, and right part, and a correct orientation) so that the holes all align. There is a small label on each part (L, C, R) in addition to an arrow that should point up on your HSW.

Prints great with no supports.

If you're using this with my multiboard cereal box filament holders, print a second center clip for the standoff.

A few caveats:

-HSW spacing (40.88mm left to right, 23.6mm up and down) does not align well with multiboard's 25mm spacing. These clips allow you to have a single small threaded hole anywhere you want, as well as to have up to 3 holes 25mm o.c. in a row.