Precision Multi-Angle Square --- Pin Holder

Here's a pin holder for a precision multi-angle square from aliexpress: Square Protractor model A Extended Upgraded

The quality of this tool is fantastic, the only minus was the lack of a holder for the angle setting pin. Well not anymore!

This precision square is now a complete tool, I like to call it a “Budget Woodpeckers”.
The pin holder fits tightly and holds the pin securely, a fantastic little print!

10 minute print time
5 minute processing & install

Instructions:
The pin holders are printed without supports, to be used in the 6 and 7 millimeters holes

Use a 6mm drill to clean up eventual print errors; cleanup is needed for a precise pin holding force
Not all the holders need to exert force on the pin. I left the last half at original print size for a snug fit, see gif:

The posts which go in the tool are a simple press fit, with the option to add a screw (8x2mm) for permanent installation:

Descrição