Overview

This propeller boat is an easy way to build a 3D-printed ship. Since it doesn't have a propeller underwater, the hull is completely sealed and watertight at the bottom.

This model uses the official-standard-remote:

Motor and Speed Controller

Because the CyberBrick motors were too weak, I used a cheap drone motor from AliExpress. If you build this, you need this motor and an ESC to control it. An adapter that fits the parts you bought is required to split the power between the receiver and the ESC.

There is currently no ready-to-use part, so you have to solder one yourself:

Instructions

You can either watch the video tutorial or refer to the assembly guide located in the documents section.