Light up your room… So your adventurers can see the skull of the previous heroes who tried to defeat the necromancer!

Use these pillars with flames made out of skulls to finish of your scenery filled with skulls.

The model is supportless.

Instructions:

• Print the tiles of your choice.
• Remove the small supporting pins on the sides.
• Print Openlock clips to connect the tiles.
• Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).
• Connect the tiles together.

Looking for the other designs to build your own necromancer lair? Use these components:

• Necromancer tiles
• Necromancer walls
• Necromancer corners
• Necromancer brazier
• Necromancer round altar
• Necromancer big altar
• Necromancer round big pillar
• Necromancer square pillar
• Scenery: pile of bones

I remixed the original tiles adding an Openlock triplex base you can click the tiles together in a limitless configuration of your choice. This way you can build the terrain easily and don't have to be scared the tiles get pushed around.

I added aditional beams, because I found that printing the big ones without them gives a very bad texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

I also made the tiles bigger, and without a border to make the room more open and added the brazier onto a tile.

Together 3D has a commercial license for using the OpenLOCK system. More info can be found on www.printablescenery.com