This is a two-tone print.

WARNING: If it isn't obvious, there will be a large amount of filament purged due to the high number of filament changes, unless you are using a dual nozzle printer. Please consider this before printing.

I have remade a Version 2 which holds 135 Sleeved Cards and can be found on Patreon: 
[https://www.patreon.com/posts/gold-flying-deck-152048158?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link](https://www.patreon.com/posts/gold-flying-deck-152048158?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link)
 

Fits Dragon Shield sleeves:
Single Sleeved:~ 100
Double Sleeved: 85

TIP: Sparkle or Galaxy filament for the main black box part tends to hide layer lines for the naked eye really well.

This box uses 4x2mm magnets.
You'll need 8 of them. I use a rubber hammer to get the 4 into the base, then put another magnet on top of each of the 4 you just hammered in, put the lid on and gently hammer the corner of the lid.
This ensures correct orientation and fit for the top magnets.

For best results, I recommend a 0.2mm nozzle for the badge and icon.
The gold badge does have a specific orientation:

 

Use a drop of glue to attach the icon to the gold badge. TOO MUCH WILL OVERFLOW. very little is needed.
Same goes for attaching the badge to the box lid.