Buy me a coffee? [https://buymeacoffee.com/practical3dp](https://buymeacoffee.com/practical3dp) 
This is the deburring tool I made this holder to work with: [https://amzn.to/49qum7F](https://amzn.to/49qum7F) (Amazon affiliate link)

NOTICE READ ME: Only works with 13.6mm diameter deburring tools. It's specifically designed to fit only the size of deburring tool that I have. Please measure your deburring tool before printing! Inside diameter is 13.7mm to fit a deburring tool which has a diameter of 13.6mm

Minimal deburring tool mount for the Multiboard. Has a tapered mouth so the tool inserts into the holder without precise alignment.

PRINT INSTRUCTIONS:

Filament: Any, PETG recommended 
Layer height: .12 (high quality for smooth curves)
Infill: 15% gyroid infill
Walls: 2 
Inner/outer wall speed: 75mm/s and lower. I lowered other speeds over 100 to 100mm/s max. Top surface speed 50-60
Supports: Manual, normal, grid supports underneath the snap on the back of the part. Use support painting to select the over hang on the back of the holder and select “on overhangs only” 
Post Processing: Remove supports with pliers if necessary. Use a razor blade to cut underneath the snap on the back of the part so it inserts into the multiboard easily. 

To create this, I made a small cup that holds a 13.6mm diameter deburring tool perfectly. I then added a moderate weight-bearing snap to the back of the part.

LICENSING: You may not use this design or file for commercial purposes. See Full License Here: [https://www.multiboard.io/license](https://www.multiboard.io/license)
Creative Commons - Attribution - Non-Commercial - Share Alike

Original Designer: [https://www.multiboard.io/parts-library](https://www.multiboard.io/parts-library)