An emerald for the item frame I designed. This item uses two of the neodymium magnets (check the bottom of the description for the link). I have also included two additional magnet holes, in case you wanted to add two extra magnets when the emerald is finished printing. The profile will have the pause necessary to insert the magnets at the right time. The magnets should fit snug, so no super glue is required to hold them in place. Just be sure to insert the magnets in the right direction so they attach in the item frame correctly!

This model is support free and does not require the AMS. If you are not using the AMS, just be sure to add color switch pauses at the same layers as in the print profile.

I have included two pauses in this profile, since this model uses six colors and I only have one AMS. The first pause is where you will insert the two magnets, and the second pause is to take the two filaments out of slots 1 and 2 of the AMS, which is the camo green and the real green, and insert light green filament into slot 1, and white filament into slot 2. When sending the file, you should map the light green filament to use Slot A1, and the white filament to use Slot A2. I have included a screenshot for better understanding:

The six different filaments I used in sequence are:

3DSolutech Camo Green PLA

3DSolutech Real Green PLA

Mika3D Green Silk PLA

Bambu Green PLA Basic

Inland Peak Green PLA

El3goo White Rapid PLA+

The link for the magnets is included in the item frame model on my page:

[https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479](https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479)