Inspire from a prior model, I basically made a thin version of the tag. This version is 1.22 mm thick, and this making it easier on a keychain. The prior I needed it for a bookbag.

Prior version: [https://makerworld.com/en/models/194121-blank-keychain-tag#profileId-214646](https://makerworld.com/en/models/194121-blank-keychain-tag#profileId-214646)

Note for this version, I have it where the text is flush. You can extend it on one side if you want. 

Also, you can extend the tag if needed. Just split it before the hole, and another on the other end before the curve. This letting you keep the curves and hole the same. And you can extend the middle part as needed.

And on the off chance you don't see it. The text is mirror on both sides. I have it going into the model 0.5 mm so it has a cutoff. This hopefully making it where if you were to use different colors on both sides it shouldn't cause too much of an issue.