Bee Pollen Cleaner! 

First, I want to say that this is an ongoing project. This is V1, and I'm uploading it to get feedback from all you beekeepers on Makerworld!

You are welcome to make changes, remixes, the goal is to create something that works for everyone and make beekeeping profitable and sustainable !

What is the idea behind this?
If you've collected bee pollen from bees, maybe you've tried my beepollen trap? Then you know that a lot of unwanted debris comes with it—bee parts, wings, legs, dirt—basically anything the bees discard ends up in the pollen trap. 

This image shows how it is constructed. The hole on the left is where the hairdryer blows air in, creating a draft over the middle where the pollen falls down. The lighter debris is blown to the right side and falls into the box on the right, while the heavier pollen falls into the left box.

At the top, there is a regulator, mainly to prevent the lighter debris from being blown up and out through the top, which was previously a problem. It also holds the sides together.

The box on the right where the debris lands has to be a little open so that air flows well! Just try it out, maybe it can be fixed with bigger or more holes in the back.

Usually, one or two runs work well, but I'm sure it can be improved.

Known issues:
Every hairdryer is different, so airflow can be a challenge.

The hairdryer might need to be placed a bit further away, about 20–30 cm..

No support or glue needed.