Instructions
Print with layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You can scale the X and Y axis but DO NOT scale the Z axis of any hueforge

Filaments Used

PLA+ Sunlu Black

PLA BambuLab Red

PLA BambuLab Sunflower Yellow

PLA BambuLab Jade White

Swap Instructions

start with Black

at 1.52mm switch to Red

at 2mm switch to Sunflower Yellow

at 2.56mm switch to Jade White

at 2.96 switch to Black

All photos are of an actual print of my hueforge design. Use the same filament and colors and you can expect the same results. Make sure your print plate is clean for good adhesion. I like to put brims on my hueforges to make sure they don't lift or warp. If you have any issues with the print, feel free to shoot me a message.

If you like this print, give me a boost!