This mini screwdriver is not much different from many other screwdrivers, yet it is exceptional in some ways.

It includes a strong neodymium magnet, 10 mm in diameter and 3 mm thick.
This reliably holds screws, and you can also insert a steel rod instead of a bit, or a hexagonal shaft drill bit, to magnetically extract small screws and washers that have fallen inside the device.

When I go flying RC models, I carry two to three of these mini screwdrivers in my pockets, each with a different necessary bit.

The CAD data also include a glued version, where the end part is glued with CA adhesive after printing.
And also a complete version (where printing is paused and a magnet is glued).
But it's not a problem to modify it in the slicer according to personal preference and print it using custom procedures.

Videos:
[https://eu.zonerama.com/mojzes/Photo/12488904/533396037](https://eu.zonerama.com/mojzes/Photo/12488904/533396037)
[https://eu.zonerama.com/mojzes/Photo/12488904/533395989](https://eu.zonerama.com/mojzes/Photo/12488904/533395989)
 

Thank you for your support.