This is a fine-tooth version of a comb made by @calmar81. My wife loved the look and feel of the original but asked for one with narrower teeth- so here it is!

Same design, you can print both combs and have nice matching ones- one thick, one thin tooth. 

Simple, functional and easy to print- no support needed. 

I'd recommend to print it out of PETG as teeth are very thin and they will snap if made from PLA.

Feedback most welcome!

Edit: Uploaded new print settings for mobile users. Recommended for general use.

Tweaks: 

-Slowed down initial layer, initial infill layer, and outer wall for better quality

- 4 arcane walls

-Infill increased to 30% for more stiffness

Orange comb was printed with these settings, using PLA matte. Happy printing!