A bed for the item frame I designed. This item uses two of the neodymium magnets (check the bottom of the description for the link). I have also included two additional magnet holes, in case you wanted to add two extra magnets when this item is finished printing. The profile will have the pause necessary to insert the magnets at the right time. The magnets should fit snug, so no super glue is required to hold them in place. Just be sure to insert the magnets in the right direction so they attach in the item frame correctly!

This model is support free and does not require the AMS. If you are not using the AMS, just be sure to add color switch pauses at the same layers as in the print profile.

I made my bed black, but you can make it any color you want to personalize it!

I have included two pauses in this profile, since this model uses five colors and I only have one AMS. The first pause is where you will insert the two magnets, and the second pause is to take the filament out of AMS Slot 1, which is the dark brown filament, and insert white filament into this slot. When sending the file, you should map the white filament to use slot A1.

The five different filaments I used in sequence are:

CCTREE Dark Brown PLA

SpiderMaker Kraft Brown Matte PLA

Bambu Black PLA-CF

Inland Light Gray Tough PLA

El3goo White Rapid PLA+

The link for the magnets is included in the item frame model on my page:

[https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479](https://makerworld.com/en/models/1249292-no-ams-needed-minecraft-item-frame-magnetic#profileId-1271479)

PRO TIP: never use a bed in the nether.