Remix Info:

I made new flower stamp inserts for the Swappable Stamp model

Summary:

Inserts (for my Swappable Stamp model) with a variety of flowers on them

Model Description:

These inserts are made to be used with my Swappable Stamp model

Printing information:

• Use a flexible material like TPU
• Print each insert in the same orientation as it came (on its flat round base)
• No supports are needed
• Ironing (with the 3d printer) the highest surface will improve the finish of the stamp and will therefore improve the stamped results, alternatively you can also sand the model down with a high grid sandpaper (220p works well) afterwards.

Note that would you wish to make your own insert, check out the blank insert in the base model that was made for this purpose.

---

To store the insert packs for the Swappable Stamp (like this one), I made this storage solution:

[https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179](https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179)

As this pack contains 12 inserts, you will need the ss_insert_storage_12 in the "Inserts only tubes" directory.

---

For more info about the stamp please check out the base model.

All the flower svgs come from SVG Repo: daisy_gaps (modified), daisy_outline (modified), daisy_simple, flower_indent, hex_flower, hibiscus, lily, lotus, orchid, rose, star_flower and tulip (by zest)