This is a movable model of the Sd.Kfz 302 "Goliath" in a scale of about 1:6 (~25 cm).

The Goliath light charge carrier, a self-destructive minitank (German: Leichter Ladungsträger – Goliath), called by the Allies "beetle-tank" was a small, remote-controlled tracked transporter produced during World War II. The transporter was designed by the Germans according to a French model that Germany captured. In the combat version, the minitank was intended to transport charges to the target and detonate them remotely. In the engineer version, it was used to create a passage through a minefield. (WiKi)

• for assembly you need:
  16x - M3x10
  14x - M2x6
  6x - M3x6
  4x - M3x20
  2x - M3 nuts
  Optional 60x - M2.5x6 or 60x printed plugs for covers

• Parts "Goliath_hull_right_left" (first 1mm is enough),
  "Goliath_sprocket" (hex hole is enough),
  "Goliath_final_drive" (hex hole is enough) must be printed with supports

• for maximum strength, do not change the orientation of the parts
• 47 track links are needed for one track
• simple assembly instructions in pdf
• most parts are snap-on

• no glue needed

• 0.2mm layer / 0.4mm nozzle

Warnings:
-The model is quite large!
-This is not an RC model (no working final drive, bearings, etc. But modification is possible)
-The hinges are difficult to snap on (V2 version is weaker,but not tested)

if you like this, buy me a beer ;)
[https://www.buymeacoffee.com/dmux](https://www.buymeacoffee.com/dmux)