If you do not have an AMS, just delete the filament changes and replace them with pauses instead. Then you can change filament manually when it pauses at the correct layer.

If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please.

Important:

1. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
2. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). 
3. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.

You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Remember to select the correct plate type for your printer.

I have used a height range modifier in the object settings for quicker printing. The layer swap numbers in the print profile will not match the ones written below. Do not worry about this.

Filaments Used:
PLA PolyTerra Charcoal Black  Transmission Distance: 0.3
PLA PolyTerra Army Blue  Transmission Distance: 0.3
PLA PolyTerra Lava Red  Transmission Distance: 1.9
PLA Esun Magenta  Transmission Distance: 3
PLA PolyTerra Sunrise Orange  Transmission Distance: 3.1
PLA Overture Highlight Yellow  Transmission Distance: 6
PLA Sunlu Meta White  Transmission Distance: 6.2
 

Swap Instructions:
Start with Charcoal Black
At layer #13 (1.12mm) swap to Army Blue
At layer #14 (1.2mm) swap to Lava Red
At layer #17 (1.44mm) swap to Magenta
At layer #18 (1.52mm) swap to Sunrise Orange
At layer #21 (1.76mm) swap to Highlight Yellow
At layer #25 (2.08mm) swap to White for the rest.