Love 2 (literally *grin*)

Print Time About 3 hrs 24 min

P1P/ Bambu Basic PLA in CMYK Colours (Total of 4 colors used)
THIS IS NOT SET UP TO CREATE WITHOUT AN AMS but i am sure it is possible
Recommended with Bambu Basic PLA CYMK & Print Profile But I use Often use other filament (Sunlu PLA+ white, Bambu PLA Magenta, Sunlu PLA+ yellow
and Sunlu PLA+ light blue)as well
Aux fan is OFF (if using one)

Settings are taken from [https://wiki.bambulab.com/en/knowledge-sharing/CMYK-color-lithophane-printing-instructions%20](https://wiki.bambulab.com/en/knowledge-sharing/CMYK-color-lithophane-printing-instructions%20)
Lithophane created with [https://lithophanemaker.com/Color%20Lithophane.html?fbclid=IwAR0zbiYVOGT2kV0MY4LtLbNk5rrg_wOd_bEsA2kpnxebZCTbBNzPyFu8h7g.#processing](https://lithophanemaker.com/Color%20Lithophane.html?fbclid=IwAR0zbiYVOGT2kV0MY4LtLbNk5rrg_wOd_bEsA2kpnxebZCTbBNzPyFu8h7g.#processing)

0.20 Standard Print Profile
First Layer .1mm
Other layers .15mm
ARACHNE walls
2 wall loops
5 top shell
3 bottom shell
INFILL: 100% rectilinear
Speed: Slow Down For Overhangs is Turned off (UNCHECKED)
Prime tower enabled
Brim/Bed Adhesion: None Needed
Flushing set for 1.00 (you will need to adjust this for your filaments and machine type but i often range between .60 and .75)