Here is a display model that I created of the 18 most common infill patterns.

Which includes.

• Rectilinear
• Line
• Hilbert curve
• Gyrated
• Tri-hexagon
• Lightning
• Cubic
• Honeycomb
• Grid
• Crosshatch
• 3D Honeycomb
• Support Hubert
• Triangles
• Concentric
• Advanced cube
• Archimedean chords
• Octagram spiral
• Aligned rectilnear

Important

The infill swatches have been created in bamboo studio by removing the top surface of each individual swatch. Therefore make sure you print from the .3MF file for a hasslefree experience. Alternatively you can print from the STL's I have provided but you will have to remove the top surface layer to reveal the infill pattern below.

I have added print profiles that are compatible with the X1C, P1S, P1P and A1 - these contain four plates that are single colour. I managed to get everything on to three plates for the H2D print profile. I have created a print profile for the A1 mini that contains six plates. I have also had to adjust the angle of the main stand, so that it prints at 45 degrees, instead of flat on the bed, and have added supports.

Lastly, just letting everyone know, I have not personally printed this model on the A1 mini. However, I have created supports that I believe would allow for a successful print of the main stand. All other components should print perfectly fine. 

The model uses 4 M3x10mm bolts and for M3 threaded heat inserts to connect the two pieces of the stand base and the stand together,  if you don't have access to M3 bolts and threaded inserts it should be possible to superglue the stand pieces together as they do not take much strain.

Have fun and hope you find this useful.