THIS WILL BREAK IF PRINTED IN PLA, PETG, ABS OR PA!

IT WILL NOT BOUNCE IF PRINTED IN TPU!

This should be printed in any of the following filaments:

BIQU PLA-HR

DUDV2 PLA-B Splat 

Sting 3D's FPLA+

This is my most advanced ball yet. When printed it should weigh in at 620g and has a bounce of about 95% of a standard basketball. 

I have uploaded single (H2D, X1C, P1S & A1) and dual colour (H2D only) versions. 

Please make sure to:

• Use a .6mm nozzle - this increases the bounce and durability of the ball
• Dry your filament
• Apply magnets to the brim as shown in the images below after the nozzle clears the height of your magnets. I would also recommend doing this to the purge tower for dual colour print

Commercial licenses available on request - drop me a message