Snap Fabric System ✦ Interlocking Cloth

Recommended Settings: 3 Walls, 20mm/s slow first layer, NO supports.

This is an EXPERIMENTAL FABRIC and having pieces come off while printing is normal! You may have to restart or try a smaller model. Brims are not advised.
Feel free to BUY me a COFFEE, thanks! ~ [https://buymeacoffee.com/triplegworkshop](https://buymeacoffee.com/triplegworkshop)

BEFORE YOU LEAVE A BAD REVIEW:

A few recommendations-

Don't use textured sheet. High-temp PEI or supertack is much better.
Start off with a smaller piece and be sure to go extra slow first layer!
Using a binder like hairspray can help. If pieces pop off that is telling you there is a problem with your setup. Clean everything and try again, you can do it!

9 different models to choose from. No supports, scales up but becomes fragile if scaled down. Fun tactile/fidget toy. Satisfying. Prints well in TPU. This is my 21st fabric!

Instructions:

Carefully interconnect each hook-and-loop one at a time and work your way across.
Push the loop vertically into each hook carefully- wiggle, don't force it!
Once all connected they will not come loose and are very strong.
Use the many shapes included to make ANYTHING!

Holler if you have questions or suggestions.

Donations are appreciated ~ [https://buymeacoffee.com/triplegworkshop](https://buymeacoffee.com/triplegworkshop)

So yeah, this is the 21st fabric I've designed. Not all of them made it to the publishing process. This one is a variant of Fabric #19, which seemed like the best base to convert for snap-together sheets. It's simple and complex at the same time.

Thanks for all the support over the years, I know how much you love these fabrics. DOZENS of people have reached out to me wishing for one that linked together and here we are FINALLY!

Close up on the hook & loop setup. When you connect them, it shouldn't be difficult, just wiggle then in- it takes a little practice to do fast.

Descrição

Recommended Settings: 3 Walls, 20mm/s slow first layer, NO supports.

Instructions: