The newest version of the AMS Riser V2 Side Mount for Multiboard. 

This is a remix from Moloch's model found here - [https://makerworld.com/en/models/996689-offset-multiboard-for-ams-riser-v2#profileId-973188](https://makerworld.com/en/models/996689-offset-multiboard-for-ams-riser-v2#profileId-973188)

This version allows for you to use your already printed multiboard without having to print a new “special” board to accommodate the mount.

Note - These mounts are specific to the front and back of the AMS Riser V2. The side mount for the back of the AMS Riser is marked with a “B”

IMPORTANT

I have shortened the side mount length from Moloch's model so the board is held higher up. Because of this, its easiest to slide the AMS Riser to the side a bit. Put the mounts on to the riser and then attach your multiboard to the mounts. 

If you need the mounts for the other side of the riser you can simply mirror the parts. 

my panel layout 

2 8x8 multiboard panels

1 9x5 multiboard panel

I already had the 2 8x8 panels before I printed the AMS Riser.. 

For this remix I used “moderate weight bearing snaps” found here - [https://thangs.com/designer/Multiboard/3d-model/Raised%20Moderate%20Weight-Bearing%20Snap-989145](https://thangs.com/designer/Multiboard/3d-model/Raised%20Moderate%20Weight-Bearing%20Snap-989145)

Be sure to check out [https://www.multiboard.io/](https://www.multiboard.io/) and [https://thangs.com/designer/Multiboard](https://thangs.com/designer/Multiboard) @KeepMaking.