Remix Info:

I made new footprint stamp inserts for the Swappable Stamp model

Summary:

Inserts (for my Swappable Stamp model) with animal footprints on them

Model Description:

These inserts are made to be used with my Swappable Stamp model

Printing information:

• Use a flexible material like TPU
• Print in the same orientation as the insert came (on its flat round base)
• No supports are needed
• Ironing (with the 3d printer) the highest surface will improve the finish of the stamp and will therefore improve the stamped results, alternatively you can also sand the model down with a high grid sandpaper (220p works well) afterwards.

Note that would you wish to make your own insert, check out the blank insert in the base model that was made for this purpose.

---

To store the insert packs for the Swappable Stamp (like this one), I made this storage solution:

[https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179](https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179)

As this pack contains 15 inserts, you will need the ss_insert_storage_15 in the "Inserts only tubes" directory/profile.

---

For more info about the stamp please check out the base model.

All the footprint svgs, except one, come from svgrepo, more specifically from the Footprints, Free Animals and Educational Icons collections (by SVG repo itself). The only exception is the elephant footprint svg, which I did myself (available here as well). 

Please note that the footprints were often not or badly identified, so I had to do it myself. Since I am not a specialist, there may be errors in the names. Here is the identification table I came up with: