Remix Info:

I used the cat alphabet letters to make stamp inserts for the Swappable Stamp model

Summary:

Inserts (for my Swappable Stamp model) with each letter of the cute cat alphabet

Model Description:

These inserts are made to be used with my Swappable Stamp model

Printing information:

• Use a flexible material like TPU
• Print in the same orientation as the insert came (on its flat round base)
• No supports are needed
• Ironing (with the 3d printer) the highest surface will improve the finish of the stamp and will therefore improve the stamped results, alternatively you can also sand the model down with a high grid sandpaper (220p works well) afterwards.

Note that would you wish to make your own insert, check out the blank insert in the base model that was made for this purpose.

---

To store the insert packs for the Swappable Stamp (like this one), I made this storage solution:

[https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179](https://makerworld.com/en/models/2205790-swappable-stamp-storage-tubes-fusion360#profileId-2397179)

As this pack contains 26 inserts, you will need the ss_insert_storage_26 in the "Inserts only tubes" directory/profile.

I have also provided an ss_insert_storage_13 model to take smaller printers into account, two of them can be printed instead.

---

For more info about the cat alphabet or the stamp please check out the base models.