Realistic flower, ideal as a decoration and a small gift.

The model takes a single flower growing from a base with two leaves, petals and pollen stems called anther or filament.

The model has tree supports that are easy to remove, as you can see from the photos.

I recommend not using silk filament to avoid problems

If printed with materials such as ASA, ABS, PETG, it can also be used as a garden decoration

A tip, especially for the less experienced, when you remove the supports, it is advisable to hold the flower by the petals and not by the base, to avoid dangerous levers and breaking the flower stem.

For the less experienced, start cutting the branches with a pair of wire cutters to initially remove those that start from the base.
The supports near the model are easily removed, leaving the model clean.

Be careful when you detach it from the plate, if it is too tight, help yourself with a spatula and do not pull the flower from the head.

The stem is full and thick, quite resistant but it is always better to be careful.
The supports between the petals, small, can be removed with a small flat screwdriver or a cutter (they also come off easily).

Always carry out these operations holding the model by the flower and not the base, so you will not make mistakes of distractions and unnecessary breakages.
(I made this note, as I realize that there are many beginners who need to learn the management of removing the supports).

For the experts... have fun with this beautiful flower!
Tested on X1C (not tested on A1 mini)

Enjoy!