Beer O' Clock! When it's always time for a beer this clock has you covered. Shaped like a bottle cap adds some fun flair to this beer clock that would look great in any game room or home bar. NO AMS REQURED! Just filament swap at the different layers to get the colors you want. There is a pre-colored AMS file also attached.

🖨️ Printing Tips

This does require supports and I suggest using a .3 air gap for the underneath. The supports will stay on the print bed when you pull it off. I also set my supports .5 away from the model. Traditional supports with a wider pattern, I used a 8mm wide pattern which was a good balance and removed very easily. The goal is just to prevent major sagging when bridging the bottom layer. Use a fine .16 layer height for nice results.

🔗 Additional Information

You do need to purchase a clock movement, they run about $10 and can get one at any craft store or big box store. Amazon has a great selection.

If you're wondering about the 'O instead of O' I have fixed it on the model but didn't want to reprint the entire model :) Mistakes happen in this fast paced world of model making.

When it comes to hardware, I rely heavily on Bambu Lab 3D printers. My A1 Mini [https://rb.gy/uofj5](https://rb.gy/uofj5) is a staple in my office, while my fleet of X1C Carbons [https://rb.gy/9r2az](https://rb.gy/9r2az) ensures rapid and high-quality production.