Shout out to @Lumpy3D for inspiring me to try to create my own Hueforge design. I made one of my most played games, and I think I'm addicted. I plan on making more for sure. Thanks again @Lumpy3D.

 [https://makerworld.com/en/@Lumpy3D](https://makerworld.com/en/@Lumpy3D)

Hueforges can be resized by changing only the X and Y scale and leaving the Z height the same.

Hueforge art of the game “Grounded”

Print at 100% infill with a layer height of 0.08mm with an 

initial layer height of 0.16mm. You may print at higher layer heights below the minimum depth of 0.48mm

The Max Depth is 2.2mm, and the Actual Depth is 2.3mm

 I used the Arachne wall generator, which causes it to take a long time to slice. I switched it to classic wall generator for the print profile, but you can switch it back if you wish.

The Model is 179.20 x 234.00 mm in size

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Red

At layer #15 (1.28mm) swap to Yellow

At layer #25 (2.08mm) swap to White for the rest.