THIS IS A REMIX!

I loved the original model from Jo at MyMinifactory, but had trouble getting good surface quality because of the rounded bottom on the handles. I took the file and flattened the bottom of both handles to serve a few purposes - 1. To make printing easier and require no supports or brim. 2. To up the quality of the print to give it a more premium look and feel. 3. To allow the switch to freestand while the handles are attached (see photos)

****The fit was a little bit loose for me, so I added a small piece of blue painter's tape to the inside of the grip to snug it up a little without making it difficult to put on and remove.****