I wanted to see the filament through the front panel and created this simple model to mount a flash light on top.

1. Unscrew the 2mm bolt under the lid to remove the handle.
2. insert the handle into the model.  (It's tight but it will snap in)
3. Re-install the handle using the original screw.
4. Insert the flash light and enjoy.  (flash light I'm using measures 24mm)

I've printed in PETG since top of the dryer and flashlight gets warm.  In order to adopt to your own flash light or similar light.  Modify the model in Bambu Studio and adjust both cylinder with your measurements. 

I'm new to this so hopefully someone who is an expert can improve this model.