Magnetic Socket Holder for the Quinn 3/8" Master Socket Set from Harbor Freight
 from diyfabshop.com, [https://www.youtube.com/@DIYFabShop](https://www.youtube.com/@DIYFabShop)
I recently purchased this socket set from Harbor Freight and got all of the sockets measured up and put this together using diyfabshop's template!

These print in multiple pieces and I just  beat them in to each other with a rubber mallet, minimal effort and did not have any issues breaking them

I have arranged these on the plates with Bambu Studio's arrange tool

I was able to print without supports without any issues

I also have made these for the Quinn ¼" Master Socket Set 
[https://makerworld.com/en/models/1211092-socket-holder-harborfreight-quinn-1-4-master-set#profileId-1225893](https://makerworld.com/en/models/1211092-socket-holder-harborfreight-quinn-1-4-master-set#profileId-1225893)

The bases of the holders have slots for bar magnets. I used These:
 

[https://www.amazon.com/dp/B0D6FFYRYP?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1](https://www.amazon.com/dp/B0D6FFYRYP?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)

[https://www.amazon.com/dp/B07DFZH4WT?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1](https://www.amazon.com/dp/B07DFZH4WT?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) 
In some instances the magnets were too long, all i did was snap/break the magnets to size using a couple pairs of pliers.