Update: Added Optional Brace - I don't use it but if you do, you can always print it afterwards if you need. Note that the brace fits the original stack, so no need to reprint anything.

Want to stack my AMS 2's, but didn't want to have the supertall versions. and didn't want to be printing for 30 odd hours. 

This one is super fast to assemble, and doesn't require glue or screws, and there are no supports required.

There is no front or back, so you just need to print the same 3 parts for each side. 

A couple of things to note before you print;

There is no cross brace, so it may feel a little wobbly. I've been running it for a couple of weeks and very happy so far.

To access filament in the lower AMS, you will need to either slide it forward, or slide the stack back. Personally, I find this a better compromise… so don't print it if you're looking for something else.

Finally, I wouldn't mount this on top of the H2D since the printer moves so much during printing.

Good luck!

Optional Brace Shown Below

Check out some of my other designs…