My custom 3D-printable version of a classic magic trick! In this illusion, coins appear to pass impossibly through a solid bolt that serves as a barrier inside the box. Prints fast without supports.

Features:

• A magic trick box with two halves. 
• A slider mechanism that works with various coin sizes
• A printable M5 bolt (though you can also use a real M5x20 bolt or similar if preferred)

Assembly instructions:

• Place the slider inside one half of the housing
• Place the other half on top of the first one. You can use a drop of super glue if needed to secure.
• Push the bolt through the middle hole in the housing (This can also be done during the trick to demonstrate that the bolt is real)

To perform the trick:

• Preparation: Place one coin into the slider and push it all the way in. The coin should fall into a cavity inside the box, allowing the slider to move to the other side
• Performing: Turn the box upside down, place another coin into the slider, and push it through

• Repeat by turning the box upside down

   

This design is part of my Gadgets -collection. Check it out for more useful prints like this.
[https://makerworld.com/en/collections/4371323](https://makerworld.com/en/collections/4371323)

If you like the design, consider buying me a coffee or contact me for a custom design inquiry at:

[https://buymeacoffee.com/tinkerer_designs](https://buymeacoffee.com/tinkerer_designs)

Check out my portfolio:
[https://makerworld.com/en/@tinkererdesigns](https://makerworld.com/en/@tinkererdesigns)