CONFIGURABLE AND STACKABLE STORAGE DRAWER SYSTEM

With this storage drawer system you can make any size storage drawer system you want. The drawer holders easily slot together for simple and easy configurability. There is also a set of drawers for a single stack. To make the system wider just use more middle drawer holders; this works for both width and height. 

With this system you can easily make your storage more flexible and save space.

Note: You do not need to print every plate. Only print the pieces you need for the way you want to configure your storage system. For example if you only want to print a 2 X 2 system print the left bottom and top, and the right bottom and top, and print four drawers (delete the middle holders from the plate before slicing). If you want to print a 3 X 3 system print the left bottom. middle and top, and the right bottom, middle and top, and print nine drawers. If you want to make it wider or taller just print more middle pieces (delete top and bottom pieces from the plate and clone the middle piece as needed), and the necessary drawers to expand your storage system. 

The single bottom, middle and top are for those who just want a single stack. If you want it higher than three drawers, just print more sing middle pieces and the necessary number of drawers.

EASY TO SLOT TOGETHER TO MAKE ANY SIZE STORAGE SYSTEM YOU DESIRE!

Notes: Can be printed in any material. The joiners were designed with enough tolerance so they slide together easily regardless of the material used (some material expands more than others). Depending on the material used the fit may be slightly loose or very tight. It was designed right in the sweet spot for easy assembly.

After printing and the print and plate has cooled, the support for the joiner recessed is easily removed.