This ultra-compact case is designed for the Raspberry Pi Zero and the Camera Module V3/V2, with built-in support for tripod mounting.
To assemble the case, you will need:

• Raspberry Pi Zero
• Raspberry Pi Camera Module V3/V2
• Short camera cable (approx. 3.8 cm)
• A few small screws (You can see them on photo)

By default, the GPIO pins are fully enclosed for a cleaner look and protection.
If you need access to the GPIO, simply cut out the top section above the pins using a utility knife or carpet cutter – the case is designed to make this modification easy and clean.

If you need a version for the Raspberry Pi Camera Module V2, please make sure to download the separate STL file labeled accordingly.