Features:

• Buttons and camera protector colors are fully customizable.
• Supports PLA, PETG, and TPU printing (showcase model printed in PLA).
• Use Arachne wall generator with a 0.4mm nozzle to prevent gaps in fine details (<0.45mm).
• Physically tested with an iPhone prototype for a precise fit.
• PLA/PETG cases may break when removing the phone.

• The installation method for the 14 Plus camera protector is different from what is shown in the video. Please refer to the following installation instructions.

  

• Due to material shrinkage, the buttons may fit too tightly depending on the filament used. If this happens, try carefully sanding the top edge of the button hole with a small file to remove any leftover support material, or scale the button’s X axis to around 98% (as shown below) before printing for a better fit.

  

• Do not remove the outer skirt on the button — it’s designed to prevent the button from falling out.

Other Cases