Keep your hose on track and your plants intact. This two-part guide stakes deep beside a bed and lets the hose roll past without crushing stems.

• Prints in two pieces
  • Stake prints flat / horizontal for maximum cross-layer strength.
  • Glide prints upright and spins freely once pressed onto the stake
• Extra-long stake (≈ 320 mm) – holds firmly in soil so it won’t pop out when the hose pulls.
• Low-friction glide – rotates as the hose moves, reducing drag, tangles and kinks.
• Outdoor-ready – PETG recommended for UV- and moisture-resistance.
• Where it helps – borders, lawns, greenhouses, raised beds, allotments.

Note: For best results, use a rubber mallet to drive the stake into the ground. If the ground is very hard, consider printing the stake with a higher infill density for added strength.