A hexagonal soap stand, sized specifically for Dr. Squatch size soap bars! 

Because hexagons, are the bestagons.

Apply mounting tape to plus mount [featuring even more hexagons!]

Don't remove wall side of tape until you are ready to mount. lol

**********************************************************************************************************************

[IMPORTANT]

 Mate plus mount with soap stand on a flat surface and apply EVEN pressure to make sure it is lined up. [keep in mind, its a tight fit [on purpose], and you may need to clean corners of inner hexagons on the back stand, due to the nature of the gap, but the mount only goes in one way, and it wont go in unless you push down evenly across all pegs.

**********************************************************************************************************************

Then mount in desired location.

 Once mounted, you can easily remove and replace stand from mounting location for easy cleaning, just pull straight out. 

[Issues with fitment only occur when the mount isn't mounted to anything.]

I recommend printing at rough draft settings for structural integrity, and for stability of mount. 

Enjoy!