You can use this to safely store your step ladder on the wall.

The wall hook has a slot where the step ladder can be placed to avoid slipping. This is optimised for ladders with a top profile with a depth of less than 42mm. The slot is located in the front to provide adequate clearance between the wall and the step ladder. The design is optimized for use with M4/M5 countersunk screws.

For best results, this should be printed on its side to maximize strength. I tried printing these with both Bambu PLA-CF and Prusament PC Blend Carbon Fiber (PCCF) with the 0.20mm Strength profile, but other tough materials may also work. Keep in mind that the choice of material and print settings will significantly impact the part’s strength and durability. Be sure to adjust and test your settings accordingly.

Disclaimer

This part is designed for specific use cases and has not been rigorously tested for all applications or materials. If you choose to use or print this part, it is your responsibility to ensure it meets your strength and safety requirements.

I am not liable for any damage, injury, or failure caused by the use of this part, inappropriate material selection, or improper printing practices.

Always thoroughly test the strength of the printed part before using it to store or support heavy or valuable items. Use at your own risk.